Solid Core Current-To-Voltage Transducers CR4310/4311

Solid Core, Current-To-Voltage Transducers, CR4310,CR4311The CR4310/11 series current-to-voltage transducer produces a 0-5 Vdc output signal that is directly proportional to the input AC current. The output signal is average-sensing, calibrated for RMS.


This transducer is used with process control and industrial instrumentation equipment. The DC output signal can be connected directly to a high impedance analog input of a computer or PLC without additional signal conditioning.


The CR4310 series will measure up to 200% of full scale on a short time basis (1 minute or less) and 150% on a continuous basis at its rated accuracy. To protect external circuits from damage caused by short circuits or motor inrush currents, the output is limited to 12 Vdc.

Wire Mounted Current Indicator
Wire Mounted Current Indicator
Wire Mounted Current Indicator
Self-powered, requires no external power source
Permanently calibrated
Output overload protected
Interfaces with most commercially available instruments
Fully isolated
10 different ranges
Calibrated Signal Out: 0-5 Vdc
Frequency: 50/60 Hz
Response Time: 250 ms max., 10-90% FS
Max. Signal Out: 12 Vdc
Industrial Instrumentation Equipment
Process Control
Over/under current sensing
CR Magnetics Current Transducer Catalog
CR Magnetics Current Transformer Catalog
CR Magnetics Commercial & Metering Class Current Transformers



Heaters Controls And Sensors Products